2:4
B
A
C
Preparations
Preparing the machine for bobbin winding
Place an empty bobbin so that the pin of the bobbin winder
snaps into the slot of the bobbin. The Pfaff logo is facing up.
Push the bobbin to the right.
Note: The bobbin can only be wound if it is moved fully to the right.
Winding the bobbin from the spool pin
Place the sewing thread on the spool pin. To obtain free
movement of the thread and hold the thread spool fi rmly, fi t a
spool cap of the right size for the thread spool.
Threading
Place the thread into guide A from the front and pull it counter
clockwise around the pre-tension device B. Make sure the
thread is pulled securely inside the pre-tension device for
correct thread tension. Pull the thread under the thread guide
C (from back to front). Wind the thread tail around the bobbin
several times in a clockwise direction.
Switch on the main switch
Hold the end of the thread fi rmly and press the foot control. As
soon as the bobbin is full, the winding action will be stopped
automatically. Push the bobbin to the left, cut the thread and
remove bobbin from the winder.
To Next Page
Loading...
Need help?
General
