2:8
A
B
C
D
Preparations
Threading the needle
Switch off the main switch.
Raise the presser foot lifter (51). Place the thread on the spool
pin and fi t a spool cap of the right size.
Using both hands, pull the thread into thread guide A from
the front. Place the thread from right to left into the pre-
tension device B. Now pass it through the left threading slot
downwards. Pull the thread around the stop C in the right
threading slot and upwards to the take-up lever (40). The
thread must be pulled into the take-up lever from left to right.
Pass the thread downwards in the right-hand threading slot.
Pull the thread from the side behind one of the two thread
guides D.
To thread the needle, please refer to the next page.
To Next Page
Loading...
