2:12
C
Preparations
Place the thread from left to right through the take-up lever
(40).
Important: The take-up lever must be at its highest position.
Winding a bobbin through the needle
It is possible to wind bobbins even when the machine is fully
threaded. Raise the presser foot lifter (51) to the top position.
Pull the needle thread underneath the presser foot and upward
through the right-hand threader slot (34).
Guide the thread to the right under thread guide C. Wind the beginning of the thread several times around the bobbin in a
clockwise direction. Push the bobbin to the right. Hold the end of the thread fi rmly and press the foot control.
To Next Page
Loading...
Need help?
General
