Need help?Do you have a question about the Phanteks Enthoo Pro PH-ES614PTG and is the answer not in the manual?
General| Case Type | Full Tower |
|---|---|
| Motherboard Support | E-ATX, ATX, Micro-ATX, Mini-ITX |
| Expansion Slots | 7 |
| Internal 3.5" Drive Bays | 6 |
| Front Ports | 2 x USB 3.0, 1 x USB 2.0, Audio In/Out |
| Fan Support Bottom | 1 x 120mm |
| Radiator Support Front | 120mm, 140mm, 240mm, 280mm, 360mm |
| Radiator Support Top | 120mm, 140mm, 240mm, 280mm, 360mm |
| Radiator Support Rear | 140mm or 120mm |
| Maximum GPU Length | 347mm (13.7 inches) / 472mm (18.6 inches) without HDD cages |
| Color | Black |
| Material | Steel, Plastic |
| Cooling Support Bottom | 1 x 120mm |
| Power Supply Support | ATX |
| Fan Support Front | 2 x 140mm or 3 x 120mm |
| Fan Support Top | 3x 120mm or 2x 140mm |
| Fan Support Rear | 1 x 140mm or 1 x 120mm |
| Maximum CPU Cooler Height | 193mm |
| Cooling Support Front | 2x 140mm or 3 x 120mm |
| Cooling Support Top | 3x 120mm or 2x 140mm |
| Cooling Support Rear | 1 x 140mm or 1 x 120mm |
| Dimensions (H x W x D) | 550 x 235 x 550mm |
| Drive Bays | 6 x 3.5" |
Details physical dimensions, materials, motherboard compatibility, and front I/O ports of the PC case.
Specifies fan compatibility for front, top, rear, and bottom mounts, including sizes.
Details radiator support for liquid cooling systems on front, top, rear, and bottom.
Step-by-step guide on how to safely remove the side panels of the PC case.
Procedure for installing the motherboard, including standoff screw placement.
Procedure for installing the power supply unit into the PC case.
Procedure for installing 3.5-inch hard drives into the drive trays.
Instructions for connecting the PWM hub's 4-pin connector to the motherboard's CPU_FAN header.
Key information regarding motherboard RPM signal reading and Y-splitter usage with the PWM hub.
To Next Page