P a g e 30 | 49
Note
Phicomm router supports two DDNS service providers: NO-IP (
www.noip.com
)
and DynDNS (
www.dyn.com
). Before you set up the DDNS, please have the
DDNS account created and the host name purchased on the service provider
website before setting DDNS on this screen.
6.8 Remote access
Using Remote Access, you can allow a user on the internet to access and manage your
router. This feature is helpful when you want to administer your router remotely.
To enable Remote Access, follow these steps below:
1. On Web Management, go to Main menu > Advanced > Remote Access and toggle
on Remote Access switch.
2. Enter the IP address of the computer that is given the access.
P a g e 31 | 49
Note
If you set Management IP as
255.255.255.255
, all devices from the
network can remotely manage your router.
3. Click Save to save the settings.
To access the router from internet, type the router's WAN IP into the address bar of a
browser, followed by a colon (:) and the port number. For example, if the WAN IP is
211.117.154.79
, and the port number you set is
8181
, enter
http:// 211.117.154.79:8181
to
manage the router via internet.
WARNING!
Turn off Remote Access if it is not used to avoid potential hazard from
internet.
6.9 Wireless Extension
By using the Wireless Extension, the main and the sub routers can be bridged to extend
coverage of the wireless network. The wireless network to be extended can be achieved by
auto-scanning (recommended) or specifying a network manually.
To enable Wireless Extension, follow these steps below:
1. On Web Management, go to Main menu > Advanced > Wireless Extension and
toggle on Wireless Extension switch.
2. WISP Mode supports automatic scan and manual input.
3. Scan: You can choose Scan to scan for wireless signals in the current network
To Next Page
Loading...
Need help?
General
Weight and Dimensions