Philips 10BDL3051T - 3.3.6.6 Remote Control Settings; Enable;Disable Web Control Function; Server Address and PIN Code Setup

10BDL3051T
20
(3) Remote Control
You can Enable or Disable the Web Control
function.
You can set the Server address. If the server is
not registered, it will need you to enter PIN Code.
Bind status::
* If not connect to network, it will show: Network is
disconnected.
* Connect to network but not Remote Control
Server, it will show: Server is disconnected.
* If the Remote Control Server is not bound, it will
show: Server is unbound.
* If it is bound successfully, it will show: Server is
bound.
* If you enter wrong PIN code, it will show Error PIN
code.