108
HUDSON 8
6. SmartResponse set to “High”.(N/A for this model)
7. Gamma Table turn off to achieve
8. Fastest response time. (N/A for this model)
9. Smart Contrast set to “On”
C. Image Viewing
i. Purpose: Design for image viewing application, especially in slide show. The screen is dominated by
picture. Powerpoint presentation could use this profile also.
ii. Enhancement Point:
1.Dynamic contrast enhancement by histogram analysis (DLC) should be off.
1. Sharpness and color to be enhanced 75%.
2. Color temperature 6500°K
3. Brightness level sets to maximum.
4. Smart Response set to “Off”. (N/A for this model)
5. Smart Contrast set to “Off”.
D. Economy
i.Purpose: Adjust brightness level for reducing power consumptions
ii.No optimization by Smart Image.
iii.Design:
1. Brightness level set to 70%, a little higher brightness level than laptop PC, fine tune brightness level
before DVT exit.
2. Color temperature set to 6500K.
3. Gamma Table is turn on.
E. Off
i. Purpose: No optimization by SmartImage.
ii. Design:
1. This will follow user OSD setting. If any change by user, it will be saved. When switch back from other
SmartImage profiles, it will go back to last saved setting.
2. Gamma Table is turn on to reduce bad color tracking.
3.16.1.7Demo mode
A. Purpose: Built-in demo mode for sales in-store demo.
B. Design:
i. Dynamically split screen to 2 vertical frames with one vertical white line. The line width is 2 pixels. The
left frame will be enhanced by SmartImage and right frame remains original performance.
ii. There is OSD showing “SmartImage On” in left frame and “SmartImage Off ” in right frame.
iii. The OSD word color is white with transparent background.
http://www.wjel.net
To Next Page
