Philips 190B8CS/00 - Electrical Characteristics; Interface Signals; Scanning Frequencies

View angle (CR>10) : >=160/160 (typ) for H/V
Contrast ratio : >=1000:1 (typ)
White luminance : >=300 nit (typ)
Color gamut : >=72% (typ)
Gate IC :
Source IC :
Response time : 5 ms
2.2 Scanning frequencies
Hor. : 30 – 83 K Hz
Ver.: 56 - 76 Hz
Video dot rate: 165 MHz
Power input: 90-264 V AC, 50/60 ± 2 Hz
Power consumption : : 36 W typical
Functions:
(1)D-SUB analog R/G/B separate inputs, H/V sync separated, Composite (H+V) TTL level, SOG sync
(2) DVI digital Panel Link TMDS inputs
2.3 Ambient temperature: 0 °C - 40 35°C
3. Electrical characteristics
3.1 Interface signals
1). D-Sub Analog
Input signal : Video, Hsync., Vsync
Video : 0.7 Vp-p, input impedance, 75 ohm @DC
Sync. : Separate sync TTL level , input impedance 2.2k ohm terminate
Hsync Positive/Negative
Vsync Positive/Negative
Composite sync TTL level, input impedance 2.2k ohm terminate (Positive/Negative)
Sync on green video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
2). DVI-D Digital
Input signal: Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)
3). Audio (Not required in this product)
Input signal: 1000 mVrms
Loudspeaker (Impedance: 16 Ohm +/-15%): 21.5W+21.5W stereo for RMS Power
Frequency range: 360 450Hz - 20KHz
Headphone connection will mute speakers
4). USB PLUG 2.0 (Not required in this product)
Input signal: Upstream input (VBUS, D+, D-, GND) via USB-B receptacle.
Output signal: Downstream output (VBUS, D+, D-, GND) through USB-A receptacle
http://www.wjel.net