7.1.2 Power Management
Status
H-sy
nc
V-sy
nc
Video Power LED
Test voltage
Power On on
on
active ≤ 58W Blue
90V/60HZ-264V/50Hz
off
on
blanked ≤0.5W
d 220V/50Hz
on
off
blanked ≤ 0.5W
Power Saving
off
off
blanked ≤ 0.5W
Blinking Blue
LED
Period: 3sec
On, 3sec Off
Power Off -- -- -- ≤ 0.5W Off
90V/60HZ-264V/50Hz
7.2 Standard Test conditions
(EE)
Unless
otherwise
specified, this
specification is defined under the
following conditions.
(1) Input signal:
As defined in Timing table, 1920 x 1080
non-interlaced mode (
1920 x 1080 @60Hz
),
signal
sources must have 75 ohm
output impedance.
(2) Luminance setting: controls
to be set to 300 nits with full screen 100 % duty cycle white
signal
(3)
Warm up:
more than 30 minutes
after power
on with
signal supplied.
(4) Ambient light:
400 – 600 lux.
(5) Ambient temperature: 20 ± 5
q
C
7.3 Test equipment
Personal computer with Windows 98/2000/XP/VISTA
Luminance meter Minolta
CA210
Videogenerator: Chroma 2227, 2230 or equivalent
Colour analyzer: Minolta or Chroma
10 times magnifier
Ruler / Template
Thickness gauge
Watt / Power
Meter
7.4 Video Generator test sequence
Will be defined by Innolux or its subcontracted quality providers.
7.5
Analog input
Analog input R,G,B level:
0 - 700 mV max.
Polarity:
positive,
negative
Impedance:
75
:
± 1%
Sync:
HV separate sync,
composite
sync,
7.6
Optical response time
Video Bandwidth:
205MHz (dot rate)
Typical
Response Time
(CPT)
5ms
7.7 Protection circuit
The monitor
will not be damaged by:
improper vertical or horizontal sync pulse (picture must be black
at improper signals, unsynchronized pictures
are not allowed
)
To Next Page
Loading...
