Philips 5000 - Customer Menu in the PHI 5000

PHI 5000 01 INTRODUCTION
10/9
Display Setting Setting Value Description
Coee
temperature
average
Coee brewing temperature set-
ting.
Stand-by
time
15 minu-
tes
Stand-by time setting.
Contrast average Display contrast setting.
Water hard-
ness
4 (very
hard
water)
Water hardness setting.
AquaClean
water
lter
to be
installed
AquaClean settings.
1.9. Customer menu in the PHI 5000
List of default settings
COFFEE
TEMP
DISPLAY
CONTRAST
ON
0/8
FILTER FILTER
ACQUA CLEAN
FILTER
0/8
180°
60°
30°
15°
STANDBY
R
4
3
2
1
WATER
HARDNESS
Changing the default settings
It is possible to customise the machine functions through the programming
menu. The machine must be turned on and ready to work.
If necessary, refer to the “8.1 List of default settings” chapter.
Press the MENU button and scroll through functions list to select the
function whose settings are to be modied:
Note: the images at the side refer to a sample function.
Once selected:
Press the UP button to increase the value.
Press the DOWN button to decrease the value.
Press the OK button to conrm the change.
When the change has been implemented, the OK message will be
displayed.
The modied but unconrmed values will not be stored.
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is
pressed for 3 minutes.
Press the OK button to select the desired function
>
>
>
>
>
>
DISPLAY
CONTRAST
MAX
MED
MIN