Philips AC2729 - Wi-Fi setup

8 EN
Note
• This instruction is only valid when
the air purier is being set up for the
rst time. If the network has changed
or the setup needs to be performed
again, consult section "Setting up the
Wi-Fi connection when the network
has changed" on page 8.
• If you want to connect more than
one air purier to your smart device,
you have to do this one by one.
Complete the set up of one air
purier before you turn on the other
air purier.
• Make sure that the distance
between your smart device and the
air purier is less than 10 m without
any obstructions.
• This app supports the latest
versions of Android and iOS. Please
check www.philips.com/purier-
compatibility for the latest update
of supported operating systems and
devices.
Setting up the Wi-Fi connection
when the network has changed
Note
• This applies when the default
network to which your purier is
connected has changed.
1 Put the plug of the air purier in the
power socket and touch to turn
on the air purier.
2 Touch and simultaneously for
3 seconds until you hear a beep.
» The air purier goes to pairing
mode.
» The Wi-Fi indicator blinks
orange.
3 Follow the steps 4-5 in "Setting up
the Wi-Fi connection for the rst
time" section.
Wi-Fi setup
Setting up the Wi-Fi connection
for the rst time
1 Download and install the
"Air Matters" app from the App
Store or Google Play.
2 Put the plug of the air purier in the
power socket and touch to turn
on the air purier.
» The Wi-Fi indicator blinks
orange for the rst time.
3 Make sure that your smart device is
successfully connected to your Wi-
Fi network.
4 Launch the "Air Matters" app and
click on the "+" on the top right of
the screen. Follow the onscreen
instructions to connect the air
purier to your network.
5 After the successful pairing and
connection, the Wi-Fi indicator
will light up white. If pairing
is not successful, consult the
troubleshooting section, or the
help section in the "Air Matters"
app for extensive and up-to-date
troubleshooting tips.