Philips AC2729 - Replacing the NanoCloud rotary humidification wick

17EN
English
8 Place the water tray and water tank
back into the appliance (g. n).
9 Touch and hold for 3 seconds
to reset the NanoCloud rotary
humidication wick lifetime counter.
Replacing the
NanoCloud rotary
humidication wick
Filter alert light status Follow this
F1 is displayed and
the lter replacement
light ashes on the
screen (g. ).
Replace the
NanoCloud
rotary
humidication
wick
1 Take the wick wheel o the wick
support (g. †).
2 Grip the shaft screw on the
other side of the wheel, rotate it
anticlockwise to release the wick
from the wheel (g. ).
3 Unfasten the locks on the edge
of the wheel successively to
disassemble the wick wheel (g. ).
4 Take the used NanoCloud rotary
humidication wick out (g. ).
5 Remove all packaging material
of the new NanoCloud rotary
humidication wick (g. l).
6 Place the new NanoCloud rotary
humidication wick in the wick
wheel, and then fasten the locks on
the wick wheel (g. ‘).
7 Place the wick wheel on the wick
support (g. m).
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.