Philips AC2729 - Descaling the NanoCloud rotary humidification wick

15EN
English
Note
• Please use mid or acid cleanser
• White vinegar (5% acetic acid)
mix with equal amount of water
• 24g citric acid mix with 4L
water
• If there are white deposits
(limescale) on the lter, make
sure that the side with the white
deposits is immersed in the water.
• Do not take the NanoCloud rotary
humidication wick o the wheel
during descaling.
5 Rinse the NanoCloud rotary
humidicationwick under the tap
to rinse away vinegar or citric acid
residues. During rinsing, turn the
wick so that both front and back are
rinsed (g. ‰).
6 Air dry the NanoCloud rotary
humidication wick (g. Š).
Note
• Do not put the NanoCloud rotary
humidication wick under direct
sunlight.
7 Touch and hold for 3 seconds
to reset the NanoCloud rotary
humidication wick cleaning time.
Note
• Make sure that the pre-lter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-lter.
5 After the pre-lter is completely dry,
place it back into the back panel
(g. h).
6 Touch and hold for 3 seconds to
reset the pre-lter cleaning time.
Descaling the NanoCloud
rotary humidication
wick
Filter alert light
status
Follow this
F0 displays on the
screen and wick&
pre-lter cleaning
alert goes on
Descale the
NanoCloud
rotary
humidication
wick
1 Pull out the water tank (g. j).
2 Lift the water tray upwards and pull
it out horizontally (g. k).
3 Take the wick wheel o the wick
support (g. †).
4 Soak the NanoCloud rotary
humidication wick in cleansing
agent (e.g diluted white vinegar,
Citric acid solution) for two hours
(g. ˆ).