Philips AC3055/50 - Cleaning the Surface of the Filter; Replacing the Filter

10 EN

 Action
The lter cleaning alert displays on the screen
(g w).
Clean the surface of the lter with a vacuum
cleaner�
1 Switch o the air purier and unplug from the power socket.
2 Pull the back cover and remove it from the appliance (g c).
3 Pull the lter from the appliance (g x).
4 Clean the surface of the lter with a vacuum cleaner (g y).
5 Put the lter back into the appliance (g f).
6 Reattach the back cover. (g g)
7 Put the plug of the air purier in the power socket.
8 Touch the button to switch on the appliance.
9 Touch and hold the lter status check/reset button for 3 seconds to reset the lter cleaning
time�
10 Wash your hands thoroughly after cleaning the lter.

Understanding the healthy protection lock
This air purier is equipped with a lter replacement indicator to make sure that the air purication
lter is in optimal condition when the air purier is operating. When the lter need to be replaced, the
lter replacement alert lights up red.
If the lter is not replaced in time, the air purier will stop operating and automatically lock to protect
the air quality in the room. Replace the lter as soon as possible.

Note:
•
The lter is not washable or reusable.
•
Always turn o the air purier and unplug from the electrical outlet before replacing the lter.
 Action
The lter replacement alert lights
up (g z)
Replace the NanoProtect lter Series 3 (FY3430/30)
1 Switch o the air purier and unplug from the power socket.
2 Pull the back cover and remove it from the appliance (g c).
3 Pull the lter from the appliance (g x).
4 Remove all packaging materials of the new lter (g e).