Philips AC3858 - 6 Storage; 7 Troubleshooting

36 EN
6 Storage
1 Turn o the air purier and unplug from the power socket�
2 Clean the air purier, particle sensor and the surface of the lter (see
chapter ‘Cleaning and maintenance’)�
3 Let all parts air dry thoroughly before storing�
4 Wrap the lter in air tight plastic bags�
5 Store the air purier, lter in a cool, dry location�
6 Always thoroughly wash hands after handling the lter�
7 Troubleshooting
This chapter summarizes the most common problems you could encounter
with the appliance� If you are unable to solve the problem with the information
below, contact the Consumer Care Center in your country�
Problem Possible solution
The appliance
does not work
even though it is
plugged in�
• Check if the back cover is properly installed�
• The lter replacement alert has been on continuously
but you have not replaced the corresponding lter� As a
result, the appliance is now locked� In this case, replace
the lter and long press to reset the lter lifetime
counter�
The airow that
comes out of
the air outlet
is signicantly
weaker than
before�
• The surface of the lter is dirty� Clean the surface of the
lter (see the chapter "Cleaning and maintenance")�