Philips AC6675 - Replacing the filters; Filter replacement indicator

42 EN
6 Replacing the
filters
Filter replacement
indicator
This air purier is equipped with
a lter replacement indicator to
make sure that the air purication
lter is in optimal condition when
the air purier is operating. When
the lters need to be replaced, the
lter code displays on the screen
(see Filter alert chart) and the lter
replacement alert ( ) lights up.
If the lters are not replaced in time,
the air purier will stop operating
and automatically lock to protect
the air quality in the room. Replace
the lters as soon as possible
according to the lter code.
Note
• To optimize the lifetime of the
pre-lter, make sure it air dries
completely after cleaning.
• Wash your hands after handling
the lter.
• Make sure the side with the two
clips is pointing towards you,
and that all hooks of the pre-
lter are properly attached to
the air purier.
7 To reattach the side panel,
mount the panel onto the
bottom of the appliance rst
(1). Then, gently push the
panel against the body of the
appliance (2).
8 Put the plug of the air purier in
the wall outlet.
9 Touch the button to switch on
the appliance.
10 Touch and hold the reset button
for 3 seconds to reset the
pre-lter cleaning time.
11 Wash your hands thoroughly
after installing lters.