38
English
Steam does not stop automatically
after placing the iron head onto
the holder.
Steam lock function is activated. Press once to deactivate steam
lock.
The board cover becomes wet or
there are water droplets on the
garment during steaming.
Steam has condensed on the
board cover after a long steaming
session.
Leave it to dry before storage.
Replace the board cover if it has
worn out. Purchase a new board
cover from a Philips Authorized
Service Center.
Board is shaky during use. The board is not secured onto the
pole.
Ensure the top pole clip is secured
to the top of the pole.
Ensure the hinge shaft is aligned
and secured to the Y bracket.
Ensure tilting lever of ironing
board is locked.
The pole is not secured to the base
of the product
Make sure the base clip is secured
and locked to the base.
Board cannot be tilted or used in
the horizontal position.
The board tilting lever has not
been released.
Ensure the tilting lever is unlocked
to allow board to be tilted to a
desired position.
Once a desired position is
attained, lock the tilting lever to
secure board.
White flakes come out of the iron
head within first few usage
sessions.
This is normal as the appliance has
gone through quality tests and
may have some residual particles.
Simply shake/ brush the flakes off
the garment. Do not use wet cloth.
Dirty water, brown stains or white
flakes come out of the iron head
and stain the garment.
Chemical or additives is added
into the water tank.
Never use chemical or additives
with the appliance. Fill the water
tank with water and allow it to
steam out 1 full tank to rinse off
chemical residues.
For stain on garment, rinse off any
stains under running water.
For stain on iron head, wipe any
deposits off the iron head with a
damp cloth.
To Next Page
Loading...
