39
English
Depending on where you stay, the
water hardness level may be high
and results in fast scale builds up.
Ensure that water tank is emptied
after a steaming session. It is
recommended to use a
combination of
demineralization/distilled water
(50%) mixed with tap water
(50%).
Hold the iron head away from the
garment and press the steam
trigger for 10 seconds to release
the initial gush of water droplets.
For stain on garment, rinse off any
stains under running water.
For stain on iron head, wipe any
deposits off the iron head with a
damp cloth.
Impurities or chemicals present in
the water have deposited in the
steam vents and/or soleplate.
Perform calc clean (see chapter
Smart Calc clean system).
The board is too high for me at
horizontal position.
Pole height is not adjusted when
changing from vertical/tilt
position to horizontal position.
Lower the pole height when
ironing horizontally.
The power light and Calc light are
blinking together or both lights
are blinking alternately.
The appliance has not heated up
sufficiently.
Power off, unplug the appliance
for 5 seconds, re-plug and power
on the appliance.
If you continue to see the error,
stop using the appliance and
contact the Consumer Care in your
country.
The light of the Calc-clean button
flashes and the appliance beeps.
This is calc clean reminder. Perform calc clean after calc clean
reminder is given (see chapter
Smart Calc clean system).
No steam comes out of the
soleplate, the light of the CALC-
CLEAN button flashes and the
appliance beeps.
This is calc clean reminder. Perform calc clean after calc clean
reminder is given (see chapter
Smart Calc clean system).
The Calc-Clean process does not
start.
Iron did not place on the calc
clean container.
Ensure iron is put on calc clean
container.
You have not pressed the Calc-
clean button for 2 seconds until
the appliance started beeping.
Perform calc clean (see chapter
Smart Calc clean system).
Water flushes out of the soleplate. You have accidentally started the
Calc-Clean process (see chapter
Smart Calc clean system).
Switch off the appliance. Then
switch it back on again. Let the
iron heat up until the power
button light turn steady.
To Next Page
Loading...
