40
English
Water droplets come out of the
soleplate.
After the Calc-Clean process
remaining water may drip out of
the soleplate.
Wipe the soleplate dry with a
piece of cloth. If the Calc-Clean
light still flashes and the appliance
still beeps, perform the Calc-Clean
process (see chapter Smart Calc
clean system).
The Calc-Clean process has not
been completed.
You have to perform the Calc-
Clean process again (see chapter
Smart Calc clean system).
Steam condenses into water in the
hose when you use steam for the
first time or have not used it for a
long time.
This is normal. Hold the iron away
from the garment and press the
steam trigger. Wait until steam
instead of water comes out of the
soleplate.
The iron leaves a shine or an
imprint on the garment.
The surface to be ironed was
uneven, for instance because you
were ironing over a seam or a fold
in the garment.
The shine or imprint is not
permanent and will come off if
you wash the garment. Avoid
ironing over seams or folds or you
can place a cotton cloth over the
area to be ironed to avoid
imprints.
To Next Page
Loading...
