37
English
Problem Possible cause Solution
The aqua tank is empty or
nearly empty.
Refill the aqua tank.
A microfiber mopping pad is
used that is not supplied by
Philips.
Only use an original Philips microfiber
mopping pad. The mopping pads can be
bought in the online Philips shop at
www.philips.com/support or at your
Philips dealer.
Lime scale has build up in the
wetting strip.
Buy a new wetting strip in the online Philips
shop at www.philips.com/support or at
your Philips dealer.
The appliance has a lower
suction power than usual.
The air channels on the
Vacuum & Wipe nozzle are
blocked.
Open the lids of the air channels on both
sides of the tube on the Vacuum and Mop
nozzle. Clean the channels. Close the lids
and turn the nozzle upside down. Clean the
air channels from the bottom.
Too much water flows out of
the aqua tank at a too high
speed.
The aqua tank cap is not
attached properly.
Check the cap and make sure it is fully and
properly closed.
The strip is not placed properly
in the bottom of the aqua tank.
Check the strip and make sure that it is
fitted properly in the bottom plate of the
aqua tank.
The floor dries with stripes. Too much liquid cleaner has
been added to the water.
Use only a few drops of liquid cleaner or
use a cleaner that foams less.
The microfiber mopping pad is
not placed correctly.
Make sure that the mopping pad is placed
correctly. Check the user manual for proper
placement.
An incorrect mopping pad is
used.
Only use Philips XV1700/01 microfiber
mopping pad for the 8000 series. The
mopping pads can be bought in the online
Philips shop at www.philips.com/support
or at your Philips dealer.
To Next Page
Loading...
