EN 47
11.6. Voice Guide
Q (HOME) A “Setup” A “Audio”
Menus to configure various settings for the Voice Guide function.
1. Use [ ] to select “Setup” in the Home Menu, then press [OK].
2. Use [
] to select “Audio”, then press [OK].
3. Use [
] to select the desired setting, then press [OK].
“Voice Guide”:
Turns On/Off the Voice Guide function.
“Voice Guide volume”:
Configures the volume of the voice.
“Voice Guide speed”:
Configures the speech rate.
“Voice Guide pitch”:
Configures the voice pitch.
“Voice Guide verbosity”:
Configures whether to read detailed information on the current item/operation.
4. Use [ ] to select the desired setting, then press [OK].
5. Press [Q (HOME)] to Exit.
NoteD
• In order to enable the Voice Guide function, the OSD language needs to be set to English or Spanish. Voice
Guide is not available in French.
• When Voice Guide is set to On, the HDMI auido and Digital audio settings are fixed to LPCM. Changing the HDMI
auido setting is only possible when Voice Guide is set to Off.
• While the Voice Guide function is enabled, operations may slow down.
• When this unit is in Resume-On-Stop mode, the “Voice Guide” setting item is grayed-out and is not configurable.
In order to configure “Voice Guide”, remove the Disc to exit Resume-On-Stop mode.
To Next Page
Loading...
