Philips BTD7170 - Connect power; Prepare the remote control; Demonstrate the features; Set clock

10 EN
Connect power
Caution
• Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the unit.
• Risk of electric shock! When you unplug the AC power
cord, always pull the plug from the socket. Never pull
the cord.
• Before you connect the AC power cord, ensure that
you have completed all other connections.
Prepare the remote control
Caution
• Risk of explosion! Keep batteries away from heat,
sunshineorre.Neverdiscardbatteriesinre.
• Risk of decreased battery life! Never mix different
brands or types of batteries.
• Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
SPEAKER OUT
VIDEO AUDIO IN HDMI
SUB OUT
SPEAKER OUT
VIDEO AUDIO IN HDMI
SUB OUT
To insert the remote control battery:
1 Open the battery compartment.
2 Insert the supplied AAA batteries with
correct polarity (+/-) as indicated.
3 Close the battery compartment.
Demonstrate the features
In standby mode, press and hold for three
seconds to demonstrate features of this device.
» The features are displayed one by one
across the display panel.
• To turn off the demonstration, press again.
Set clock
1 In standby mode, press and hold CLOCK
on the remote control for three seconds.
» [24H] or [12H] hour format is
displayed.
2 Press / to select [24H] or [12H]
hour format.
3 press CLOCKtoconrm.
» The hour digits are displayed and begin
to blink.
4 Repeat steps 2-3 to set hour and minute.
Note
• If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
• You can view clock information in power-on mode by
pressing CLOCK.
a
b
c