6 Hooking Up the TV/VCR
1
Connect an antenna or cable
signal to your TV/VCR using one
of the following connections.
Hooking Up Your TV/VCR With a
Cable Signal or Outdoor Antenna
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT Jack
on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.
Connect a Cable signal
or an antenna to the
ANT(enna) Jack.
Hooking Up Your TV/VCR
With a Cable Box
To view any channel, set the TV/VCR to the
Cable Box output channel (channel 03 or 04).
Then, select channels at the Cable Box.
A.
B.
Connect the Cable signal to
the IN Jack on the Cable Box.
RF coaxial cable
(not supplied)
To Next Page
Loading...
