Philips CD-I - Using the CD-I Player

4. Connect the Short AC power cable between the upper
AC outlet of the MMC module and the AC inlet of
the CD-I player.
Note: Set the POWER switch on the CD-I player to "ON"
to make full use of the power-on/stand-by system.
2-5. Using the CD-I player
Note 1. When you start to control the player by means
of the function buttons on the CD-I player,
you are allowed to change to use of the CD-I
remote control function buttons at any
moment.
When you start to control the player by means
of the function buttons on the CD-I remote
control, you will not be allowed to change to
use of the CD-I player function buttons,
unless you STOP the disc.
2. The function buttons of this unit operate only
with CD-DA and CD-V discs. If a CD-I disc is
inserted, only the EJECT button remains
operative. In such a case, operate the unit
from the MMC module.
3. The CD-I player module must be used with the
MMC module to play CD-DA discs. It should not
be used with other audio equipment.
4. To help you to locate buttons easily, the names
used throughout the text are the same as those
marked on the CD-I player. The numbers between
brackets refer to Fig. 2-1.
5. Always keep the CD-I player power switch in
the "ON" position, and control the system by
using the CD-I remote control or the Stand by
system switch of the MMC module.
2-6
www.icdia.co.uk