Philips CD-I - Graphic Control Summary and Installation

5-3. Sununary of controls and connections
1 and 2. Action buttons:
The
same functions as·
the
equivalent action
4
8
4
keys on the CD-I remote
,-#§
3-
control.
3. Panel:
Characters, graphics,
patterns and pictures are
drawn on the panel and the
coordinates are entered.
4. Input device (control) connector:
5.
6.
Connects the Graphic control
with the MMC module.
Touch pen: A special purpose
pen which is used to draw the
characters, graphics, patterns
and pictures.
Pen holder: Storage for your
touch pen when it is not in use.
7. Side attachment slots: Use this
to joint mechanically with the
CD-I remote control.
2 1
6
8. Connector stowage: Stowage for your Input device
(control) block connector when it is not in use.
5-4. Installation
The following are supplied with your Graphic control:
- Mechanical slide connector
- Input device (control) block connector
- L/R attachment endcaps
1. Making sure that the MMC is switched off, connect
the Input device (control) cable to the Input
device (control) port, located at the front of the
MMC module.
5-2
1 2
7
5
www.icdia.co.uk