Philips CD-I - Using the MMC Module

9. Finally connect the AC power cable supplied with the
MMC between the AC inlet of the MMC module and the
wall socket.
3-5. Using the MMC module
1. Press the Power switch on the CD-I player module to
"ON".
2. Press the POWER switch on the MMC module to •oN• to
make full use of the power-on/stand-by system.
- The Power on LED (3) lights.
Note: When you press the System Stand-by switch (1) on
your MMC module.
- The System Stand-by LED (4) lights.
- The Power on LED (3) is off.
Note: If the MMC module and the CD-I player are in
the power-on mode the CD-I system will be
switched-on completely, and the respective ·Power
LEDs will light. However the TV/Display and the
Hi-Fi system will have to be switched-on
separately, and set up to receive the MMC output
signals.
3. The system will show a small animated sequence,
ultimately revealing a standard control screen.
r
-...,,
CD•I
~[}(]O[LO~~ il
II
-
"
Datc/Timc
I ( CLOC/ I
Main function buttons
-
- , SYSTEM I
Display area
I (CDAU; I
- [t]" __ ,
I
I I
I
II
I~ .
0
.~~
I
I
I
Control buttons
Standard control screen
With a cursor . control device we can select from
this control screen:
3-9
www.icdia.co.uk