Philips CD-I - Graphic Control Introduction and Precautions

5-1 . Introduction
This Graphic control can be used in combination with
your CD-I system as an alternative to the CD-I remote
control. It offers faster control and input of
graphical data for graphics-based applications.
5-2. Precautions
Avoid direct sunlight, humidity and dust when using
and/or stori~g the Graphic control.
- Put the Graphic control on a flat, firm table or
desk.
- Make sure that your MMC module is turned off before
connecting the Graphic control.
- Only use the touch pen supplied when you use the
Graphic control.
- Never disconnect the Graphic control from the MMC
module by simply pulling the cable. You have to
pull out the connector.
- Never carry the Graphic control when fixed to the
CD-I remote control by the mechanical connector.
- Do not use solvents such as benzine or alcohol since
they may cause damage to the surface. If your
Graphic control becomes dirty, wipe it with a soft
cloth or use a neutral cleaning liquid.
5-1
www.icdia.co.uk