Philips CD-I - Player Installation

14. Mechanical hook (L/R):
For mechanical fixation to the MMC module.
2-4. Installation
Note 1.
2.
The CD-I player has to be installed together
with the Multi Media Controller (MMC) module.
Connections and controls are shown in
Fig. 2-1.
The following are supplied with your CD-I player
module:
- Short AC power cable
- Side endcaps (fitted on the unit)
- Two (2) CINCH cable links
- Side cover
- Three (3) CALOT CD loading trays
1. Place the CD-I player on top of the MMC module and
fix the two units together by turning the two
hooks located on the sides of the CD-I player with
a coin.
2. Remove the Side endcaps fitted to both the MMC
module (upper) and the CD-I player (lower) by
unscrewing them.
3. Connect the two (2) CINCH
cables supplied between
the corresponding DO and
RS jacks on the MMC module
and the CD-I player.
rnr~::s~;:_~~
For the protection of the
interfaces, you have to
fit the Side cover supplied
with the screws.
2-5
CD-I Player
MMCModulc
Side
cndca lower
RS/DO connection
www.icdia.co.uk