Philips CD-I - Mouse Introduction, Precautions, and Installation

4-1. Introduction
This mouse can be used in combination with your CD-I
player system, as an alternative to the remote control.
When the CD-I player system is used on a desk, for
instance, the mouse offers generally easier control and
selection facilities.
4-2. Precautions
- The mouse is a very precise mechanical device, so
handle with care. Do not drop or hit it.
- Do not use the mouse in locations subject to extreme
temperatures (either high or low), humidity, dust
and vibration.
- Be sure that you place the mouse on a clean flat
surface.
- Do not carry the mouse by holding the cable.
- Do not disconnect the mouse from the MMC module by
simply pulling the cable. You hav .e to pull out the
connector. It may cause damage to the cable and/or
the connector.
4-3. Installation
Ensure that the MMC is switched off, and connect the
connection cable to one of the Joystick/Mouse ports,
located at the front of the MMC module. The ports are
numbered 1 and 2. When using one hand control only, use
port 1.
4-4. Using the mouse
1. The mouse can most easily be used on a level surface
where it can be moved about 25 cm (10") in all
directions.
4-1
www.icdia.co.uk