Philips CD-I - Memory Card Installation and Use

6-4. Installation and use
The following are supplied with your Memory card:
- Lithium battery (CR 2016)
- Screwdriver
- Protection case
To install a battery:
1. Remove the two screws with screwdriver supplied.
(They are quite tiny so take care not to loose
them. )
2. Remove the battery cover
3. Put in a lithium battery (CR2016) supplied, positive
(+) side outward and push it all the way in
(Battery life is about five years.).
4. Screw the cover to the Memory card again .
Insert the Memory card i n the Memory card slot, located
at front of your MMC module with "THIS SIDE UP"
printing on the card facing you. Push it right in until
fix into the connector in the Memory card slot.
Note: Before using the Memory card, remove a protection
film on the card .
WARNING: NEVER INSERT OR REMOVE THE CARD WHEN THE MMC
MODULE IS SWITCHED ON.
6-5. Additional information
- Changing the Battery
All data memory written into the card memory is
lost when the battery is removed.
1. Remove the two screws with the screwdriver supplied.
2. Remove the battery cover.
6-2
www.icdia.co.uk