Philips CD-I - Using the Expansion Module

2. Press the Stand by system switch on your MMC module.
- POWER indicator (2) of the Expansion module
lights (together with the POWER indicator on
the MMC module).
Note:
Always keep the Expansion module POWER switch
in the on position and control the system by
using the CD-I remote control or the SYSTEM
POWER switch of the MMC module.
3. Floppy disks
- As this Expansion module is equipped with HD floppy
(2 MB unformatted) disk drives you are advised to
use 3.5" disks with the indication 2HD. 2DD disks
can be used too, but in the 1 MB mode only.
- When you need to change to a 2HD (2DD) disk after
using a 2DD (2HD) type, you should re-establish
the specified directory by using "chd" command.
-
Please note that new disks have to be "formatted"
before they can be used. Also note that 3.5" disks
have a write protect switch.
- To take the floppy disk out of the drive use the
EJECT button. Do not exchange the disks during an
application unless the application asks you to do
so.
Note:
Never change a disk when the 'busy' indicator
is on.
7-7
www.icdia.co.uk