Philips CDR 765 - Analogue Recording from an External Source; Erasing & Playing; Erasing CD-RW Discs; Playing CDs on Deck 1 and;or Deck 2

RECORDING
fa,)
• TochecktheIremaining}recordingtime,pressOISPLA¥.
(Thiscanalsobedoneduringrecording)
3 To stop recording, press STOP on the CD Recorder/Player
-1' CD-SYNCand RECOROgo out
• Tointerrupt recording,press PAUSE
4 RECORDstarts to flash. To resume,pressPLAYon the
CORecorder/Player
After recording the display will show LlPd,qkE for several
Seconds.
Note:
TheCDRecorder/Playerwill not start until it recognizesa
digital signal.Although thereaction time is less than 200
mi!liseconds`the verybeginning of the musicmay
sometimesnot be recorded.If this happens,youcan start
the recordingmanually(see digital recording-
unsynchronized).
Recordingsfrom DATor BCCwill onlystopafter 20
secondssilence
Analogue recording from_an external source I
Onlymake analogrecordingsif digital recordingis not
possible
Preparing for analogue recording
1 Make surethe discisabsolutelyfree ef scratchesand dust
particles
2 PressSOURCErepeatedlyuntil:
ANALOGappearsonthe display.
t _qno, S'S
I(f(t_
! ANALOG
i
* {f necessaH,press OUALte switch off the OUALmode;
OUALwill nolonger appearon the display.
r
ii
3 PressAUTO/MANUALto switch between auto andmanual
track numbering.
-) If Auto isselected)preferred),AUTOTRACKappearson
the display.
• AUTO: The track numberisautomatically incremented
after a silenceon the original of at least 3
seconds.
• MANUAL: Tracknumberscanbe incrementedmanuallyby
pressing_. )minimumtrack length is 4
seconds).(Thiscanalso bedonein AUTO
mode)
• Tracknumberscannotbechangedafter recording.
#,With the recorderstopped,press RECORDto enter Record
standbymode.
-Ik REGOROwill flash
, q
i _ ' L;, l
i t;_'q ' .... , ,:
16