16 EN
• To tune to a programmed radio
station, press its corresponding
numeric button
, , ,
, , or .
Program stations manually
1 Tune to the target detected station (see
‘Tune to a detected station’ on page 15).
2 Press / repeatedly to select a band.
3 Press and hold a numeric button ,
, , , , or to assign
a sequence number to the station.
» [SAVED] is displayed.
» The station is programmed with the
sequence number.
4 Repeat the steps above to program more
stations.
• To tune to a programmed radio
station, press its corresponding
numeric button
, , ,
, , or .
Display DAB information
The name of current DAB station is displayed.
You can also view the other information.
To cycle through available information, press
DISP repeatedly.
• Dynamic label segment (DLS)
• Signal strength
• Program type (PTY)
• Ensemble name
• Frequency
• Signal error rate
• Bitrate codec
• Time
• Date
Set up for weak reception
When the current reception gets poor, the
product can automatically switch the source or
mute the speakers according to your setup.
1 Press and hold to access the system
menu.
» [DAB SCAN] is displayed.
2 Press / repeatedly until
[DAB WEAK] scrolls.
3 Rotate to select an option, and then
press
to conrm.
• [WEAK MUTE]: Mute the speakers
• [WEAK TO FM]: Switch the source
to an FM radio station with strong
reception that broadcasts the same
program
Use the DRC (Dynamic
Range Control)
DRC adds or removes a degree of
compensation for the differences in the dynamic
range between radio stations.
1 Press and hold to access the system menu.
» [DAB SCAN] is displayed.
2 Press / repeatedly until one of the
following options is displayed.
• [DRC OFF]: No compensation applied.
• [DRC LOW]: Medium compensation
applied.
• [DRC HIGH]: Maximum
compensation applied.
3 Rotate to select an option.
Disable the DAB reception
1
Press and hold to access the system
menu.
» [DAB SCAN] is displayed.
2 Press / repeatedly until
[ANTENNA OFF] or [ANTENNA 12V]
is displayed.
To Next Page
Loading...
