Philips DTM9030 - Set Clock; Turn on

12 EN
Note
• If you are not going to use the remote control for a
long time, remove the batteries.
• Do not use old and new or different types of batteries
in combination.
• Batteries contain chemical substances, so they should
be disposed of properly.
Set clock
1 In standby mode, press and hold PROG/
CLOCK SET for more than two seconds
to activate clock setting mode.
» The 12 hour or 24 hour format is
displayed.
2 Press / to select 12 hour or 24 hour
format, and then press PROG/CLOCK
SET.
» The hour digits are displayed and begin
to blink.
3 Press / to set the hour, and then press
PROG/CLOCK SET.
» The minute digits are displayed and
begin to blink.
4 Press / to set the minute.
5 Press PROG/CLOCK SET to conrm.
Turn on
• Press .
» The unit switches to the last selected
source.
Switch to standby
• Press again to switch the unit to standby
mode.
» The backlight on the display panel is
reduced.
» The clock (if set) appears on the
display panel.
To switch to Eco power standby mode:
• Press and hold for more than two
seconds.
» The backlight on the display panel
turns off.
To switch between normal standby mode and
Eco power standby mode:
• Press and hold for more than two
seconds.
Note
• If no button is pressed over 15 minutes in standby
mode, this unit goes to Eco power standby mode
automatically.