Philips DTM9030 - 8 Listen to the Radio; Tune to a Radio Station; Select Stereo;Mono Broadcast; Program Radio Stations

18 EN
8 Listen to the
radio
Tune to a radio station
Tip
• For optimal FM reception, fully extend and adjust the
position of the FM antenna.
1 Press FM to select the FM tuner source.
2 Press and hold / for more than two
seconds.
» [SEARCH] (search) is displayed.
» The radio tunes to a station with
strong reception automatically.
3 Repeat step 2 to tune to more stations.
• To tune to a weak station, press /
repeatedly until you nd optimal
reception.
Select stereo/mono broadcast
For stations with weak signals: to improve the
reception, change to monaural sound.
• In FM tuner source, press MODE/MONO/
STEREO to select a setting:
• [STEREO]: stereo broadcast.
• [MONO]: monaural broadcast.
Program radio stations
Tip
• You can program a maximum of 20 preset radio
stations.
Program radio stations automatically
• In FM tuner mode, press and hold PROG/
CLOCK SET for more than two seconds
to activate automatic programming.
» [AUTO SRCH](auto search) is
displayed.
» All available stations are programmed
in the order of waveband reception
strength.
» The rst programmed radio station is
broadcast automatically.
Program radio stations manually
1 Tune to a radio station.
2 Press PROG/CLOCK SET to activate
program mode.
» [PROG] (program) blinks on the
display.
3 Press / to allocate a number (1 to 20)
to this radio station, and then press PROG/
CLOCK SET to conrm.
» The preset number and the frequency
of the preset station are displayed.
4 Repeat the above steps to program other
stations.
Note
• To overwrite a programmed station, store another
station in its place.
Select a preset radio station
• In FM tuner mode, press / to select a
preset number.
• You can also press the numeric key to
select a preset number directly.