English
Video Cassette Playback 15
• Other tape playback features are
on pages 29-32.
• If AUTO REPEAT is ON,playback
will begin when you insert a tape,
even when the record tab is
intact.Details are on page 29.
• You must connect the DVD/VCR
to a TV using the audio/video
cables in order to use the VCR
features.These hookups are
explained on pages 9 and 11.
Helpful Hints
Read and follow the steps below to play a tape.
1
Turn on the TV. Set it to the correct Video In
channel. (Check your TV owner’s manual for details.)
Details are on page 8.
2
Insert a tape in the cassette compartment of
the DVD/VCR. VCR light will appear on the front of the
DVD/VCR.If the tape’s record tab has been removed,
playback will start automatically.
If the DVD/VCR power is already on,press VCR to put the
DVD/VCR in VCR mode if necessary. VCR light will appear
on the front of the DVD/VCR.
● If playback does not start automatically,press VCR,then
press PLAY B.
● Press STOP C to stop playback.
● Press REW h to rewind the tape.
● After the tape stops,press STOP/EJECT CA on the front
of the DVD/VCR to remove the tape.
1
2
Turn on the TV.
Insert a tape in the
DVD/VCR.
To Next Page
Loading...
