Philips EasyKey DDL709-FVP-7HWS - Add a One-Time PIN Code; Add a Face ID; Add or Change a Master Fingerprint; Modify Master PIN Code

10
1
Add a user PIN code: Enter a new user
PIN code, and press【#】to conrm, then
re-enter the user PIN code and conrm
with【#】again. After the voice prompt
of “succeeded”, press [*] to back to the
previous menu until exit the master mode.
Add a user ngerprint: Place the nger on
the ngerprint sensor, and you will hear a
voice prompt of “please remove your nger
and place it on the sensor again”, take your
nger o and put it back again, repeat
several times until you hear a voice prompt
of “succeeded”, then press【*】to return to
the previous menu until you exit the master
mode.
Add a user key tag: Enroll a new key
tag, when you hear a voice prompt of
“succeeded”, press【*】to back to the
previous menu until you exit the master
mode.
1
Master mode User settings
Master PIN code
Add a user PIN code
Master ngerprint
After lighting up the keypad, press [*] twice
before entering other numbers, then enter
the master PIN code and conrm with [#],
then you are in master mode.
Press [*] twice, enter the master PIN code,
and then press [#] to conrm.
Press [1] to enter user settings, and then
press [1] to add a user, the door lock will
automatically recognize the corresponding
access method and add PIN codes,
ngerprints, and key tags directly.
After lighting up the keypad, press [*] twice
before entering other numbers, then place
your enrolled master ngerprint on the
ngerprint sensor to enter master mode.
Attention
Attention
If the master PIN code is the initial PIN code, you
will need to enter [1] and then [5] in the master
mode to modify the master PIN code before you
can perform other operations.
1. Please enroll a master ngerprint before using
the product.
2. Please do not set the master ngerprint and user
ngerprint with the same nger.