6
1 2
3
4
Assembly procedure
The following assembly procedure applies to the right-hand swing doors. For
left-hand swing doors, please read through the [Notice before assembling] and
complete the adjustable latch instructions.
To drill holes in the door according
to the drilling template, mount the
mortise into the jamb, and tighten the
four anchor screws.
Pass the connecting cable through
the hole, align and insert the square
shaft of the outside escutcheon into
the rotary hole, so that the outside
escutcheon is tight against the outside
of the door.
Fasten the xing plate to the inner
surface of the door and use two M5
connecting screws to secure it tightly.
Attach the connecting screw tube on
the outside escutcheon and put the
compressed spring and square shaft in
the square shaft hole accordingly.
Attention Attention
Please make sure the dead bolt are retracted
during assembly.
Please choose the appropriate length of the
square shaft and screw tube according to the door
thickness.
M6 connecting
screw tube
M6 connecting
screw tube
Connecting cable
Mortise
connecting cable
Escutcheon
connecting cable
Antenna
M5 connecting
screw tube
Antenna
To Next Page
Loading...
