WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you
are unable to solve a problem by following these hints, consult your dealer or service centre.
Problem Solution
CD OPERATION
“NO DISC” is displayed. – Insert a disc.
–Check if the disc is inserted upside down.
–Wait until the moisture condensation at the lens
has cleared.
–Replace or clean the disc, see “Maintenance”.
“DISC NOT FINALIZED” is displayed. –Use a finalised CD-RW or CD-R.
Troubleshooting
Maintenance
Cleaning the Cabinet
Use a soft cloth slightly moistened with a mild
detergent solution. Do not use a solution
containing alcohol, spirits, ammonia or abrasives.
Cleaning Discs
When a disc becomes dirty,
clean it with a cleaning cloth.
Wipe the disc from the centre
out.
Do not use solvents such as
benzene, thinner , commercially
available cleaners, or antistatic spray intended for
analogue records.
Cleaning the disc lens
After prolonged use, dirt or dust may
accumulate at the disc lens. To ensure good
playback quality, clean the disc lens with Philips
CD Lens Cleaner or any commercially available
cleaner. Follow the instructions supplied with
cleaner.
Cleaning the Heads and the Ta pe Paths
To ensure good recording and playback quality,
clean the heads
A
, the capstan(s)
B
, and
pressure roller(s)
C
after every 50 hours of
tape operation.
Use a cotton swab slightly moistened with
cleaning fluid or alcohol.
Yo u can also clean the heads by playing a
cleaning tape once.
Demagnetising the heads
Use a demagnetising tape available at your
dealer.
RADIO RECEPTION
Radio reception is poor. – If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
–Increase the distance between the Mini HiFi
System and your TV or VCR.
TAPE OPERATION/RECORDING
Recording or playback cannot be made. –Clean deck parts, see “Maintenance”.
– Use only NORMAL (IEC I) tape.
–Apply a piece of adhesive tape over the missing
tab space.
The tape deck door cannot open. – Remo ve and reconnect the AC power plug and
switch on the system again.
GENERAL
The system does not react when – Remove and reconnect the AC power plug and
buttons are pressed. switch on the system again.
Sound cannot be heard or is of poor – Adjust the volume.
quality. –Disconnect the headphones.
– Check that the speakers are connected correctly.
–Check if the stripped speaker wire is clamped.
The left and right sound outputs are –Check the speaker connections and location.
reversed.
The remote control does not function – Select the source (CD 1/2/3 or TUNER, for
properly. example) before pressing the function button
(É,í,ë).
–Reduce the distance between the remote
control and the system.
–Insert the batter ies with their polarities
(+/– signs) aligned as indicated.
–Replace the batteries.
–Point the remote control directly towards the IR
sensor .
The timer is not working. –Set the clock correctly.
–Press and hold CLOCK•TIMER to switch on the
timer.
– If recording or tape dubbing is in progress, stop
recording.
Not all lighted buttons are showing light. – Press DIM to select DIM OFF display mode.
The Clock/Timer setting is erased. –Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer.
The system displays features –Press and hold Çon the system to switch off
automatically. the demonstration.
Troubleshooting
MAINTENANCE AND TROUBLESHOOTING
1-10
To Next Page
Loading...
