Philips GoGear SA2VBE - Update VIBE; Manually verify; update the firmware

10
4 Update VIBE
VIBE is controlled by an internal program called
rmware. Newer versions of the rmware may
have been released after you have purchased
VIBE.
The software program called Philips Songbird
can use your computer to check for rmware
updates that are available on the Internet.
Install Philips Songbird on your computer
(see chapter Install software) and follow the
instructions to update (see chapter Manually
verify/updatethermware).
Note
Your music les are not affected by a rmware •
update.
Manually verify / update the
rmware
1 Ensure that your computer is connected
to the Internet.
2 Connect VIBE to the computer (see
section Connect and charge for
instructions).
3 On your computer, click Start >
Programs > Philips > Philips Songbird to
launch the Philips Songbird application.
4 Select Tools > Updates
» Philips Songbird checks for updates
and installs new rmware from the
Internet, if available.
5 Follow the on-screen instructions to
update the rmware of VIBE.
6 Wait until the update is completed, then
disconnect VIBE from the computer.
VIBE restarts after the rmware is »
updated and is ready for use again.
EN