55
ENGLISH
55
Machine actions Causes Solutions
Co ee is not brewed, is
brewed slowly or only a few
drops are brewed (see note).
The co ee grind is too ne. Change co ee blend or adjust
grinding as explained in the “Adjust-
ing the Ceramic Co ee Grinder”
chapter.
The circuit is not primed. Prime the circuit (see the "Using the
Machine for the First Time" chapter).
The brew group is dirty. Clean the brew group (see the
"Weekly Cleaning of the Brew
Group" chapter).
The dispensing spout is dirty. Clean the dispensing spout and its
holes.
The machine circuit is clogged by
limescale.
Descale the machine.
Co ee leaks out of the dis-
pensing spout.
The dispensing spout is clogged. Clean the dispensing spout and its
holes.
No hot water or steam is
dispensed.
The hole of the steam/hot water
wand is clogged.
Clean the hole of the steam wand
using a pin.
Make sure that the machine is
o and has cooled down before
performing this operation.
The circuit is not primed. Prime the circuit (see the
"Using the Machine for the First
Time" chapter).
The machine circuit is clogged by
limescale.
Descale the machine.
The Classic Milk Frother is dirty. Clean the Classic Milk Frother.
The descaling cycle cannot
be completed.
The water dispensed for the rinse
cycle is not enough.
Press the on/o button and follow
the instructions described in the
“Interruption of the Descaling Cycle”
section.
Note:
These problems can be considered normal if the co ee blend has been
changed or if the machine has just been installed. In this case, wait until
the machine performs a self-adjusting operation as described in the "Saeco
Adapting System" chapter.
To Next Page
Loading...
