21
English
To set the time duration
1 From the home screen, go to [Settings] > [Clock
settings] > [Sleep timer].
Or, press
• SETTINGS on the remote control
to enter [Settings].
2 Select an option. Press OK to turn it on.
Date and time
The date and time can be set automatically or manually.
Automatic setting
For automatic clock setting, use the time signal from
FM RDS radio.
Through time signals from FM RDS radio
1 On the unit, turn on the FM radio, if necessary.
Ensure that the FM antenna is connected
•
properly (see ‘Connect the FM antenna’ on
page 12).
2 On the rst location for preset stations, store an
FM RDS station that transmits time signals.
3 From Home screen, select [Settings] > [Clock
settings] > [Date and time].
4 In [Date and time], select [Current date and
time] > [Automatic (RDS)].
The unit searches for the rst preset station »
automatically.
The time is set according to time signals from »
the station.
Manual setting
1 Turn on the unit, if necessary.
2 From Home screen, select [Settings] > [Clock
settings] >[Date and time].
3 In [Date and time], select [Current date and
time] > [Manual].
4 To enter date and time,
Press
• or to select the entry location;
Use the alphanumeric buttons to enter
•
desired digits;
Press
• OK to conrm.
You can also press
• or repeatedly, or
press and hold
or until the desired
digit appears.
Set date/time format
Select how date and time are displayed in the clock.
Press and hold • / , or press /
repeatedly until you reach the desired digits.
Press OK to conrm.
Or, enter the desired digits by using the
•
alphanumeric buttons on the remote
control.
The alarm icon »
appears on the screen.
To play a song or FM radio station as the next alarm
sound
1 Ensure that you have selected [Music] in the Step
3 above;
2 Before you turn off MCD900, or switch MCD900
to active standby,
Go to
• [USB], and select and play the
desired song;
Or, go to
• [FM radio], and tune to the
desired station.
Note
Keep the USB ash device connected to •
MCD900, if you select a song as the alarm
sound.
Tune to an FM radio station that is in service
•
at the set alarm time, if you select FM radio as
the alarm sound.
Use the alarm
At the set alarm time, music/FM radio plays as desired,
or the buzzer sounds.
Note
The alarm sounds even if you have switched •
MCD900 to active standby or Eco standby.
The buzzer sounds instead, if MCD900 fails to
•
detect a USB ash device.
MCD900 is unmuted if it has been muted.
•
The alarm sounds in a higher volume if the •
volume level is lower than minimum.
To snooze the alarm
Press any button on the unit or the remote
•
control (except for the volume buttons).
The alarm sounds again 15 minutes later. »
The alarm icon remains.
To stop the alarm
Press and hold
• or .
The alarm is stopped. The alarm icon »
disappears.
The alarm sounds again next day. »
To turn off the alarm
Go to
• [Settings] > [Clock settings] >
[Alarm]. Select [Alarm off] and press OK
on the remote control.
Sleep timer
With the sleep timer, you can have MCD900 turned
off automatically after the set timer duration.
EN
To Next Page
Loading...
