Philips MX5100VR/37 - Channel Setup

28 Channel Setup
Although your System may automatically memorize the channels you
receive when you turn it on for the first time, you can set up the
channels again.
1
Press VCR,then press DISC/MENU so the main menu
appears.
2
Press o or p to select CHANNEL SET UP. Then,
press B.
3
Press o or p to select AUTO SET UP. Press B.
4
AUTO SET UP will flash while the System sets up the available
channels.When setup is complete,the lowest available channel
will appear on the TV.
Now when you
press SKIP i /CH o or SKIP j /CH
p,you will scan only through available channels.You still can
select any channel using the Number buttons.
AUTO SET UP
CH 01
  
  
  
B
-MENU-
[OFF]
[ON]
TIMER PROGRAMMING
AUTO REPEAT
CHANNEL SET UP
CLOCK SET
LANGUAGE SELECT
AUDIO OUT
TV STEREO
SAP
B
-MENU-
[OFF]
[ON]
TIMER PROGRAMMING
AUTO REPEAT
CHANNEL SET UP
CLOCK SET
LANGUAGE SELECT
AUDIO OUT
TV STEREO
SAP
B
•You cannot program channels if
you are using a Cable Box or
Satellite Receiver.
• If you have an antenna, channels
2-69 will be possible.If you have
Cable TV,channels 1-125 will be
possible.
•To stop Channel Setup, press
DISC/MENU while AUTO SET UP
is flashing.
Helpful Hints
STANDBY-ON
TIMER SET
VCR/TV
SEARCH MODE
REPEAT
TUNER
3
456
789
SLOW
0 +10
2
1
VCRDVD
CLEAR
DISPLAY
SETUP/
PROG
TITLE RETURNMODE/SPEED
C-RESET
AUDIO/
BAND
ANGLE
SUBTITLE
ZOOM
DISC
MENU
OK
PAUSE
REW FF
PLAYSTOP
SKIP/
CH
SKIP/
CH
REPEAT
SOUNDSURROUND
+–
VOLUME
REC
A-B
PHILIPS
4
2-3
1
MX5100VR.qxd 6/04/2004 3:37 PM Page 28