DVD to Videotape Duplication 41
Follow the steps below to copy a DVD to a videotape.
This will be possible only if the DVD is not copy protected.
Before you begin:
● Put a videotape in the cassette compartment. Make sure the tape’s
record tab is intact and the tape is long enough to record the
DVD.
● Put the DVD you want to copy in the disc tray.
● Press VCR so the red VCR light appears on the front of
the System.
● Turn on the TV.
1
Point the remote control at the System.Press Number
buttons 0, 0, 3.“DISC” will appear on the TV screen in the
top right corner briefly.The DVD logo will also appear.
2
Press MODE/SPEED until the desired tape speed (SP
or SLP) appears briefly in the lower left corner of the
TV screen.Details about tape speed are on page 77.
3
Press REC I to start recording.The red RECORD light
will appear on the front of the System.
4
Press DVD. Press PLAY B to play the DVD.
5
To pause the recording,press VCR,then press PAUSE k
once. The red RECORD light will flash.To resume
recording, press REC I or press PAUSE k again.The
red RECORD light will come on again.
6
To stop recording, press VCR, then press STOP C.
•A Timer Recording is not possible
during DVD to Videotape
duplication.
•You cannot select Tuner mode
during DVD to videotape
duplication.
• The recording will not be clear if
the DVD has copyright protection.
Helpful Hints
To Next Page
Loading...
