Philips NTX400 - Get started; Connect FM antenna; Connect AM antenna; Prepare the remote control

8 EN
3 Get started
Caution
• Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
laser exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Connect
Connect FM antenna
Note
• For better reception, fully extend and adjust the
position of the FM antenna.
Connect the supplied FM antenna to the FM
jack on the back of the main unit.
Connect AM antenna
Note
• For better reception, adjust the position of the AM
antenna.
1 Assemble the AM loop antenna.
2 Connect the AM loop antenna to the AM
jack on the back of the main unit.
Prepare the remote control
Note
• Danger of explosion if battery is incorrectly replaced.
Replaceonlywiththesameorequivalenttype.
• Batteries contain chemical substances, so they should
be disposed of properly.