Philips NTX600 - 5 Listen to Radio; Tune to a Radio Station; Program Radio Stations Automatically; Program Radio Stations Manually

15EN
5 Listen to radio
Tune to a radio station
Tip
• Keep the unit away from other electronic devices to
avoid radio interference.
• For better reception, fully extend and adjust the
position of the antenna.
1 Slide CROSS FADER to the far left.
2 Press TUNER on the remote control, or
A on the main unit repeatedly to select FM
or AM tuner.
3 Press and hold or for 2 seconds.
» [SEARCH] (search)isdisplayed.
» The radio tunes to a station with
strong signal automatically .
4 Repeat step 3 to tune to more stations.
• To tune to a station manually, press
or repeatedlyuntilyoundoptimal
reception.
Program radio stations
automatically
Note
• You can program a maximum of 30 FM and 10 AM
radio stations.
In tuner mode, press and hold PROG for 2
seconds to activate automatic program mode.
» [AUTO](auto)isdisplayed.
» The unit stores radio stations with
sufcientsignalstrengthautomatically.
» After all available radio stations are
stored,therststoredradiostationis
broadcast automatically.
Program radio stations
manually
Note
• You can program a maximum of 30 FM and 10 AM
radio stations.
1 Tune to a radio station.
2 Press PROG to activate the program
mode.
» A position number is displayed.
3 Press ALB/PRESET+/- to allocate a
number to this radio station, then press
PROGtoconrm.
4 Repeat steps 1-3 to program other
stations.
Tip
• To overwrite a programmed station, store another
station in its place.
Select a preset radio station
In tuner mode, press ALB/PRESET+/- to select
a preset number.
Change AM tuning grid
In some countries, the AM radio frequency step
between adjacent channels is 10 kHz or 9 kHz.
• In AM tuner mode, press and hold for
morethanveseconds.
» All preset stations are erased and need
to be re-programmed.