18 EN
7 Other features
Mix sound
You can play from Source A (Disc/USB A/
Bluetooth/Tuner/AudioinAmode)andfrom
Source B(USBB/AudioinBmode)atthe
same time.
1 Play from Source A.
• Disc: Select the CD source, and play a
track in the loaded disc.
• Tuner: Select the Tuner source, and
tune to a radio station.
• Audio in A: Select the Audio in
A source, and play audio on the
connected external device.
• USB A: Select the USB A source, and
play audio on the connected USB A
device.
• Bluetooth: Select the Bluetooth source,
connect a Bluetooth device, and then
play audio on the device.
2 Play from Source B.
• Audio in B: Select the Audio in B
source, and then play audio on the
connected external device.
• USB B: Select the USB B source, and
then play audio on the connected USB
B device.
3 Use the CROSS FADER control to adjust
the output balance between the two tracks
played from Source A and Source B.
Speak or sing with a
microphone
With this unit, you can speak or sing to a music
source with a microphone.
1 Turn the MIC volume knob to the
minimum level.
2 Connectamicrophone(notsupplied)to
the MIC socket on the top panel.
3 Press CD, TUNER, USB A, AUDIO A, or
AUX to select a source, and start play.
4 Sing or speak through the microphone.
• To adjust the volume of the source,
press VOL +/-.
• To adjust the volume of the microphone,
turn the MIC volume knob.
Note
• The MIC input is designed for dynamic coil microphones
with750Ω+/-30%impedance.
Turn the decorative light on
or off
• In power-on mode, press LIGHT
repeatedly to adjust the decoration light
around the loudspeakers, or turn the light
off.
Reverse the display
• During play, press FLIP to reverse the
display.
Listen through a headphone
Note
• When you listen through a headphone, the loudspeaker
cannot be muted.
1 Plug a headphone into the socket on the
top panel of the main unit.
2 Press A/B to select an audio source to
listen from: Source A or Source B.
3 Turn the volume knob to adjust the
headphone volume.
To Next Page
Loading...
