To Next PageTo Next Page
Need help?Do you have a question about the Philips PDIUSBD12 and is the answer not in the manual?
General| Brand | Philips |
|---|---|
| Model | PDIUSBD12 |
| Category | Motherboard |
| Language | English |
Provides an overview of the PDIUSBD12 evaluation kit and its purpose in USB development.
Lists the necessary hardware and software components for the PDIUSBD12 evaluation kit.
Details the physical setup and configuration procedures for the evaluation board.
Explains how to configure jumpers on the ISA bridging board for I/O, IRQ, and DMA settings.
Identifies and describes the main physical components on the evaluation board.
Explains how to use the D12TEST.EXE application for testing PDIUSBD12 endpoints.
Describes the functions of different endpoints and outlines available test modes like scan, print, and loop-back.
Illustrates the system architecture, showing interaction between the evaluation board, host PC, and device PC.
Details the I/O addresses used by the PDIUSBD12 evaluation board for data and control registers.
Describes the bit functions for the general input and output ports, including switches and LEDs.
Lists the pin assignments and descriptions for the 25-wire connector on the evaluation board.
Details the PAL equations used for address decoding and command interpretation.
Provides the detailed circuit diagram for the PDIUSBD12 evaluation board.
Presents the circuit diagram for the PDIUSBD12 ISA bridging board.
Lists all components, quantities, and references for the PDIUSBD12 evaluation board.
Lists all components, quantities, and references for the PDIUSBD12 ISA bridging board.
