Initial operation 8
3Initial operation
Setting up the device
Place the projector on a flat surface in front of
the projection surface. In case you need to tilt
the device slightly upwards (e.g.: when using a
tripod) you can correct the distortion by using
the built-in keystone correction.
Connect power supply /
charge battery
Power is supplied through the power supply
(included), one end is connected to the power
jack on the rear side of the device, the other
end to the AC100
~240V wall outlet.
Navigation for settings menu
Navigation can be done by navigation keys
(¡/¢/À/Á/à and
).
Navigation keys:
¡/¢ –
Scroll trough the settings menu.
à
– Go one level down.
In the final level, à accep
ts a setting and
automatically returns to the last submenu.
– Go one level up.
The
key aborts a setting and
automatically returns to the last submenu
(or exits the menu depending on the menu-
level).
Initial installation
1 Push the POWER button for 3 seconds till
the power indicator turns to green to turn
th
e device on.
2 T
urn the device towards a suitable projection
surface or wall. Note that the distance to the
projection surface must be a minimum of
0.5 meters and a maximum of 5 meters. Make
s
ure the projector is in a secure position.
3 U
se the focus wheel on the right side to adjust
the image sharpness.
4 The first time you turn on the device, you
should finish the main settings.
Setup language
In order to change the menu language, proceed
as follows:
1 When the device is turned on, press the à
button to enter the menu Settings.
To Next Page