Initial operation 9
Image settings
Keystone
Use À/Á buttons to correct a distorted
image.
Projection mode
Front: Normal projection; the device is located
in front of the projection surface/ screen.
Rear: Rear projection; the device is located
behind the projection surface, the image is
horizontal mirrored.
Ceiling: T
he device is hanging from the ceiling in
an upside down position; the image is rotated
by 180 degrees.
Rear ceiling: Th
e device is hanging from the
ceiling in an upside down position behind the
projection surface, the image is rotated by
180 degrees and horizont
al mirrored.
Wall colour correction
Colour correction of the projected image to
adjust to coloured projection surfaces.
Smart settings
Select predefined settings for brightness /
contrast / saturation / sharpness.
Brightness: Ad
just brightness
Contrast: Ad
just contrast
Saturation: A
djust saturation
Sharpness: Ad
just sharpness
Sound settings
Volume: Adjust the volume
Bass: Ad
just bass level (low frequencies)
Treble: Ad
just treble level (high frequencies)
Brightness mode
Adjust brightness levels to save power and
increase battery play time.
Presentation mode: Provid
es full brightness
also in battery mode.
Battery playback time will be
reduced.
Optimal mode: This is the perfect balance
between good brightness and playback time in
battery mode.
Eco mode: I
ncreases the operating time for the
built-in battery.
The brightness will be reduced to
save power!
Flashlight
Use your projector as a flashlight.
SOS light
Use your projector as SOS light.
Warning light
Use your projector as warning light.
Maintenance
Reset settings: Reset settings to factory
defaults.
Firmware update:
Allows you to update the
firmware to the latest version which can be
downloaded from the Web at
www.philips.com
Information: Display the information on the
device (firmware version / device name /
model).
To Next Page